The production of vertical high-speed injection molding machines is a very complex process. During a manufacturer's production process, there are many temperatures to be aware of. These temperatures have a large impact on the setting of the product, which is a critical factor. In the production process of the vertical high-speed injection molding machine, the following temperatures should be paid attention to material temperature, oil temperature, and mold temperature.
During the production process of the vertical high-speed injection molding machine, due to the continuous movement of the equipment, the hydraulic oil in the equipment will constantly rub against each other, generating more and more heat and increasing the oil temperature. Therefore, during the production process, the oil temperature should be checked in time to keep the oil temperature at a normal temperature of around -45°C. If the oil temperature is too low or too high, it will bring various effects on the pressure transmission of the system and affect normal production.
The material temperature is also a problem that needs attention, and the material temperature is what we usually call the barrel temperature, which generally depends on the specific requirements of the materials and products used. In the production process of the vertical high-speed injection molding machine, the material temperature changes continuously with the different production requirements, so it needs to be adjusted in time, but it cannot exceed the temperature required by the standard. Additionally, cycles and materials need to be considered.
Mold temperature is also an important reference temperature and parameter in the production of vertical high-speed injection molding machines. The mold temperature has a great influence on the shape of the product and whether it meets the standard. Therefore, when setting the mold temperature, product factors must be considered, not just temperature requirements, which will affect the normal and orderly progress of each process, and the standard rate of the produced products will be very low.