News

  • How to solve the easy breakage of the injection molding machine rod

    How to solve the easy breakage of the injection molding machine rod

    Everyone knows that the tie rods (green columns) of ordinary shaft type (machine hinge) injection molding machines of injection molding machines are easier to break than the fully hydraulic tie rods. Qingdao Jiaozhou injection molding machine shaft type design, due to the consideration of fragmentar... read more

    Feb 10,2020 News
  • How to use BMC injection molding machine correctly

    How to use BMC injection molding machine correctly

    Pay attention to point one, check whether the safety protection device of each part of the BMC injection molding machine is intact. When using BMC injection molding machine, please pay attention to point two. Check and test whether emergency stop and various safety protection alarms can work correct... read more

    Jan 19,2020 News
  • Choice of injection molding machine

    Choice of injection molding machine

    Which aspects of the injection molding machine should be selected 1. Know your own production capacity and purchase an injection machine that matches the required production capacity. The equipment is for production. Then it must reach the capacity required by the production process so that it can m... read more

    Jan 11,2020 News
  • Performance advantages of vertical injection molding machines

    Performance advantages of vertical injection molding machines

    Performance advantages of vertical injection molding machines: Performance is a product condition that all products have, and the use of functions is very important for 80% of products. The same principle applies to vertical injection molding machines. Because the development and application of mech... read more

    Jan 03,2020 News
  • Main structure of injection molding machine

    Main structure of injection molding machine

    The injection molding machine is divided into plunger injection molding machine and screw injection molding machine according to the plasticization method. According to the transmission mode of the machine, it can be divided into hydraulic type, mechanical type and hydraulic-mechanical (link) type. ... read more

    Dec 27,2019 News